Configuring Dynamic Hunt Groups
Create hunt groups that allow dynamic login and logout. In the hunt group below the '*' denotes a wildcard slot for a single hunt group login. Up to 20 wildcard slots are allowed on the UC500.
config t
ephone-hunt 1 peer
pilot 255
list 201, *, *
final 298
no-reg pilot
statistics collect
ephone-hunt 1 peer
pilot 255
list 201, *, *
final 298
no-reg pilot
statistics collect
Add the ability for an ephone-dn to login or logout. In the ephone-dn of any extension you would like to have the ability to login or out of huntgroups needs the 'ephone-hunt login' command.
ephone-dn 3 dual-line
number 203 no-reg primary
label 203
description ccc Smith
name ccc Smith
call-forward busy 299
call-forward noan 299 timeout 10
corlist incoming user-domestic
translation-profile incoming CallBlocking
ephone-hunt login
Enable the feature access code(FAC) to allow the extension to dial the login and logout codes for the hunt group(s). There are two ways to add the access codes using fac standard or fac custom.
config t
telephony-service
fac standard
config t
telephony-service
fac custom ephone-hunt join *3
fac custom ephone-hunt cancel #3
end
Dynamic login to a hunt group when one hunt group is configured.
dial FAC code '*3'
*3 login
#3 logout
Dynamic login to a hunt group when multiple hunt groups are configured.
dial FAC code '*3 + hunt group pilot number'
*3255# login
#3255# logout
