Article ID:362
Objectives
This article details how to reset and reconfigure the WET200 back to factory defaults.
Note: All settings will be lost, the IP address of the device will be 192.168.1.226 and the username and password will both be restored to admin.
Applicable Devices
• WET200
Reset WET200
There are two ways to reset the unit: press the Reset button at the back of the unit, or through the web interface.
Reset by Pressing Reset button
Locate the Reset button at the back of the unit. Press and hold the Reset button approximately 10 seconds to restore it back to factory default.
Reset through Web Interface
Step 1. Access the web interface of the WET200 by entering in the IP address of the device in a web browser and entering the correct username and password. Choose Administration > Factory Defaults. The Factory Defaults page will open.
Note: The default IP address of the device is 192.168.1.226, the default username and password are both admin.
Step 2. Click the Yes radio button.
Step 3. Click Save to begin the process of restoring factory default settings. A pop-up confirmation window will open.
Step 4. Click OK in the pop-up window to confirm and begin restoring factory default settings.
Step 5. Wait a few minutes for the process to complete. The Basic Setup page will open when complete.