cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
583
Views
0
Helpful
0
Comments
Andrew Hickman
Cisco Employee
Cisco Employee

By default, SRP520W-U products are shipped with 1.02.xx firmware, which is the tested and supported release train for this series of products.

If you need to run 1.01 release firmware, this is possible, however you MUST factory reset before AND after changing release train.  This reset process is required whether changing from 1.01.xx to 1.02.xx code, or vice versa.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: