on 06-10-2012 04:54 PM
NOTE: This is the initial release of firmware for the RV042G router.
RV042 v3
RV082 v3
RV016 v3
Release Notes:
http://www.cisco.com/en/US/docs/routers/csbr/rv0xx/release/source_4-2-1-02.pdf
Regards Simon
http://www.linksysinfo.org
At time of writing I don't know if this includes the RV042G that is due to be released in the next few days. perhaps someone from Cisco can comment on this?
The release note can be found at the bottom of the page.
http://www.cisco.com/en/US/products/ps9923/prod_release_notes_list.html
Tekai
cant seem to find the 4.2.1.02 release notes on that page though.
Updated.... This is the initial release of firmware for the RV042G router.
I have the RV016, I can't tell if it's V3 hardware. Where can I find out and what would happen if a older router had the new firmware specified for V3 flashed onto it?
What firmware revision do you have on the RV016?
if you flash v3 on anything else than a v3 router you would either fail or it will brick your router.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: