Connect with link a Juniper SRX100 and Cisco Small Business SG200-50

[Fernando Velez Varela]

Hello I need to resolve a situation. I´m connecting a Switch Cisco Small Business SG200-50 with a Juniper SRX100, I can to access to switch cisco without restrictions, but the Juniper is owned from a provider, they give me the the connection to internet, they say me that it's all Ok. In this situation, my hosts don´t pass by the interface of the Juniper. What I need to configure in Cisco Switch or in the Juniper SRX100 for resolve this situation?  

[devils_advocate]

It really depends on what sort of port they have configured for you.

Have they given you an IP range or an IP address to use?

Without knowing the type of port they are expecting you to plug into, it would be difficult to help.

Are you using a single VLAN on the SG200?