Switches - Small Business

Hello, I'm pretty new to networking and managed to get hold of an SG200 and some other hardware. The rest appears to be working perfectly, however the SG200-18 seems to reboot every 12 seconds. The power light flashes continually (I assume normal f...

Hello, is it possible to install this Switch inside a 10" Rack? Are there any accessories available to do this? Thanks for answering Meik

Hai team,                 My name is arun . I have one issue. Please help me using your valuable advice. I have one Scenario . We have two cisco switches sg 300 and two firewall Sophos UTM 230. One fire wall is master and other is slave for high ava...

Hi All, Have you ever seen below message on SG500 switch before ? Jul 12 04:21:18 atviesw01 1 2016-07-12T02:21:17Z atviesw01 SYSLOG - OSFATAL - %SYSLOG-F-OSFATAL: FATAL ERROR: GOAH: ABORT DATA exception ***** FATAL ERROR ***** SW Version : 1.4.5.02...

hi  i am trying to stack 2960S and X . Looks like its compatible for stack, I am not sure why stack is not getting formed. Your help is greatly appreciated

Hi, i've a Linksys SGE2000P switch witch had original firmware 1.0.0.45. I've upgraded the BOOT Software Version to 2.0.0.03 successfully via xmodem than i've tried to push firmware 3.0.0.17 also the same way witch went successful also but when reboo...

I have a SG300 that is running 1.4.5.02 and need some help with ACL's. My intention is to lock things down where services aren't accessible from the outside. Here is the configuration at the moment. We've tested and SSH and HTTPS are accessible from ...

Hi, I am pretty new to networking with Cisco equipment, but we have had an RV325 now for a while that I've gotten used to and have a couple VLANs set up on. We had been running with just the RV325 and a WAP371 supporting about 35 associated devices a...

I have 9 PCs at a SG300-10 switch running. Everything works fine, however, in the RAM memory log I can see permanently DOWNs and UPs. What is the reason for that behaviour? Another swtich SG300-20 does not show this behaviour.214748332717/12/12 10:10...

http://www.cisco.com/c/en/us/products/switches/350-series-managed-switches/literature.html Why there is no documentation?  No Maintain and Operate Guides, no Reference Guides, ...

Hello, I was hoping someone could help with a potentially easy (stupid) question.  I have powered up the switch and the system light is blinking green.  Now I want to and want to add it to an existing network.  According to the quick start guide, whe...

I am very rusty with commands but i was curious with these 3 sg500 setup in a stack. For some reason when i run the sh run command it does not show me any ports past 1/1/36 but if i do a show interface description it shows me all the interfaces for a...

We have 2(two) SG300-28 switches. We have several VLANS that need to be truked between switch A and switch B 1. We are able to create 1 TRUNK port  that includs vlan 2,3,4 and it works fine between switch A and B.  We are now trying to create a 2nd T...

Hello!  I have 5 of SG500X-24 PORT GIGABIT WITH 4-PORT 10-GIGABIT STACKABLE MANAGED SWITCH that i have recently started managing.  Recently, those switches have been acting up and makes our drive go down with internet connection for some of our users...