04-29-2011 11:31 AM
Hi,
I need create 2 vlans (vlan 10 and vlan 30) in Cisco 300 Series Switch.
VLAN 10 need be default VLAN (no tag).
After I wish associate port 1 to VLAN10 and port 2 to VLAN 30. The two ports must be access.
Can anyone give a step-by-step for this??
Best Regards.
Solved! Go to Solution.
05-01-2011 10:12 PM
Hi Andre,
Made a fiour minute video to show you how to create two vlans and I believe answer your question.
After you make the changes, i have suggested, be sure to save the configuration within the switch.
( the audio died whilst i was starting to save the running config to the startup configuration )
Also , it isn't indicated clearly, but in the "port to VLAN" page make sure you select go after you select a VLAN to modify. See the encircled go button in the screen shot below.
Click here to see the 4 minute video or the link below;
|
regards Dave
05-01-2011 10:12 PM
Hi Andre,
Made a fiour minute video to show you how to create two vlans and I believe answer your question.
After you make the changes, i have suggested, be sure to save the configuration within the switch.
( the audio died whilst i was starting to save the running config to the startup configuration )
Also , it isn't indicated clearly, but in the "port to VLAN" page make sure you select go after you select a VLAN to modify. See the encircled go button in the screen shot below.
Click here to see the 4 minute video or the link below;
|
regards Dave
05-02-2011 06:07 AM
Really Thanks David. Very good the vídeo.
In my config VLAN 10 is default VLAN. This make any change in configurantion of the ports?
One more time thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide