Switches - Small Business

Hi there,I'm trying to get the following running.I have 4 SubnetsVLAN 1       172.20.0.0/16        with the default GW 172.20.200.254VLAN 10     192.168.10.0/24     with the default GW 192.168.10.2VLAN 59     192.168.59.0/24     with the default GW 1...

Hello,Searched through conference and still have no resolution.Switch: Cisco SGE 2000Layer3 mode enabled through consoleswich has following configuration (from lcli):console# sh version SW version    3.0.0.18 ( date  08-Nov-2009 time  16:21:37 )Boot ...

I was wondering if the 100 series switches support link aggregation (802.1AX/802.3ad), and if not, what are the most low-end switches that do? We're using an SMB NAS device with dual Gigabit Ethernet ports that supports link aggregation, and we're lo...

Newbie here, never seen a Cisco, or any other L3 switch before. Nor an Lx router. To me, the interface is a bit confusing.Truth is, I am over my head. Can anyone suggest a step by step,or class room or web based training, or a partner or Cisco helper...

Hello!I have a question about ACL and binding. I have a SG300 28P and a couple of other linksys switches and Access points that are connected to it via trunks. The cisco SG300 28P  is running in layer3 mode and i have created a couple of vlans and on...

HelloI am having a hard time finding documentation on how the RMON is interfaced in the sg 200-26 switch. Is the statistical data only available internally, or can it actually be probed? Is there a proprietary cisco tool i can use?-Anders

I can't access the WEBGUI on any of them.  they are very busy, the network is working fine, but I can't connect to the webgui on them.  I've even had problems with a few connecting to them via HyprTerm.  I bought 7 of the 12 just last May.  If I'd kn...

I've reviewed both the administrator guide and the switch reference guide and I am still unclear about the following questions.  Will someone please help me out?  Thanks!My configuration:  2 x SGE2000 switches stacked.  SW1 GBIC3 to SW2 GBIC4.1. Sinc...

What i am trying to achive is allow only specific mac addresses on switch and deny all others by using MAC ACE.What should i do?First deny any any and then permit or ?Thank you.

I have a config issues between Wiffi device WRT320N and switch SRW224G4. some body please share your knowledge. thanks all !Topology:Description:Server DHCP windows: ip 192.168.5.14Switch core 2960: vlan 5, vlan 20Switch access SRW224G4: vlan 5, vlan...

Hello all,I have configured my SF 302-08P switch to perform 802.1X & MAC authentication. This works fine in both cases but I cannot get the switch to send accounting requests to my RADIUS server. Even when the server sends back an Acct-Interim-Interv...

Wie lang darf das Stackverbindungskabel maximal sein (Cat5/6) ?Hintergrund: 2 SGE Switche stehen ca. 60 meter voneinander entfernt und sollen über Cat6 als Stack betrieben werden.Google translation:How long can the cable be a maximum stack (Cat5 / 6)...

Ok, so we had a switch get taken out by lightning.  It gives a green status light but nothing else.  i replaced a blown cap and then, your gonna love this, rub a paperclip across some of the connections which does a soft reset and then it works great...