Resolved! SD-WAN transit for SDA
Hi All, I'm really struggling to find a good resource of integration of SDA & SD-WAN for configuration so OMP carries the SGT & for the mapping of VRFs/VPNs. Anyone aware of any decent info out there? Thanks
-
-
-
-
This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community
-
Forum Posts
Hello all, I have a question: Let say I have a VN where most devices are silent hosts. I have a controller which is connected to one of the Edge gateways and when I enable Layer 2 Flooding for this VN, Multicast traffic sent from this controller is f...
I have two border nodes ( c9500 ) version 16.09.05 connected to EDGE node ( c9400 ) version 17.03.01 i start a LAN automation and i create a fabric i make the connection with two fusion router my problem is the lik between two border not change to L3...
Resolved! DNA Center License registration
Hi everyone, I have this problem when trying to register licenses, but they fail, I don't know if I am missing a step or if it cannot be done. The problem is that within DNA center I associate a switch in License Manager -> Manage Smart License -> re...
HiMy customer has asked for the bundle license R-ISE-10VM-K9= however the part codes is EOL and R-ISE-VMM-K9= given as the replacement What I don't understand is do I need to quote the customer 10 x R-ISE-VMM-K9=? Thanks
Resolved! intermediate/edge node
Can a single node act as a SDA intermediate node and a SDA edge node simultanously? If it's possible, what is the best way to provision this kind of node?
Hey guys, is there a way to combine SD-Access and ACI in general?Currently we have our Campus-Network set up with Catalyst Switches and our Datacenter with Nexus Switches.I'm looking for a way to combine the two SDN solutions and operate them paralle...
Hello, On what base does Assurance define the “Inter-device Link” ports? If one of those ports are down, it results in P1 Event ‘Interface Connecting Network Devices is Down’, and the device 360 health is reduced to 8/10. Our issue comes with Access ...
.
Dears, I have border and control node ( one box) and it is down due to power problem and need to replace with RMA and after getting the new device how to replace it at the DNA as a border and control node ? is there is any automation process i must ...
Hello everyoneRecently our management is deciding weather to invest in Cisco SD Access/DNA center or not.I have looked a bit into Sd Access and I would like to know how it is different and better than traditional switching.If I could get some documen...
Resolved! C9300 as both distribution and edge
Can i use a c9300 (16.12.4) as both a distribution switch (the fiber ports) and edge switch (copper)?
Hello, Can I now create or delete port channels between the fabric broder ports and the fusion ASA(HA active/standby mode) uplinks?
Hello All, Assembling a large SD-A design for one of our customers, and we have devised several topology models to categorize each of their sites against from a design perspective. We allocate Catalyst 9300 and 9300L's as Edge nodes, depending on t...
Hi everyone,I have one fabric subnet which I use only for ISE Certificate Provisioning. I have WLAN with related subnet. I want people when connected to this WLAN, to browsers pop up ISE certificate provisioning page. I configured WLAN passthrough in...
