02-12-2024 04:11 PM
Hello, Could anyone help me, please? How can I design a SDA scenario in a ring topology, where I have one C9607R in main site and 42 others C9407R (with access module). The ring is by 40G QSFP+ In the main site we'll have ISE, DNAC, Fusion Router and services that will connect to C9600. What Will role of each C9400 (backbone)?
Solved! Go to Solution.
02-13-2024 09:54 AM
Hi Marcus, it would also be fine to have the C9400 as a ring of 42 IN (Intermediate Nodes) with 9300L EN (Edge Node) homed to those INs. It depends on whether you want endpoints to connect directly to the C9400s, if no endpoints connect to C9400 then I agree it's better to leave them as INs in order to keep the network as simple as possible. Hope I have understood correctly. Best regards, Jerome
02-12-2024 05:38 PM - edited 02-12-2024 05:39 PM
Not that i come across SD-Access deployed in RING, SD-Access was introduced to prevent loop and move from standard Layer 2 to VXLAN. you have extended nodes in the topology.
some reference :
https://www.ciscolive.com/c/dam/r/ciscolive/global-event/docs/2022/pdf/BRKENS-2832.pdf
02-12-2024 06:16 PM
02-13-2024 12:07 AM
YES I guess since i have not tested, this only theoretical document says possible (Generally extended node used Cat 9300 or any IE switches) - but as per i know that is possible to do better check with SE and Cisco TAC for the confirmation, Cat 9400 is not a simple cost models the investment high.
02-12-2024 10:07 PM
Hi Marcus, so you want a 42 node ring of 9407 switches? And this ring will be a single Fabric Site? Will the 9407 switches be access switches? If yes then you can build a ring of Fabric Edge Nodes, that is supported. All EN (Fabric Edge Node) need /32 in underlay GRT for all other ENs, BNs and CPs in the Fabric Site. Use whatever IGP suits you and tune it appropriately. Regards, Jerome
02-13-2024 06:02 AM
@jedolphi - this is the current idea, the C9400 with the modules to support network access and all within the same fabric. Previously, each ring node would be a backbone with uplink to two or three C9300L (access). In this scenario, I had imagined that each C9400 as an Intermediate Node and the 9300L as an Edge. But I'm trying to make the drawing as simple as possible.
02-13-2024 09:54 AM
Hi Marcus, it would also be fine to have the C9400 as a ring of 42 IN (Intermediate Nodes) with 9300L EN (Edge Node) homed to those INs. It depends on whether you want endpoints to connect directly to the C9400s, if no endpoints connect to C9400 then I agree it's better to leave them as INs in order to keep the network as simple as possible. Hope I have understood correctly. Best regards, Jerome
02-13-2024 12:09 PM
Thank you @jedolphi and @balaji.bandi
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide