Hi,I am a bit stuck with DNA-C and the interrelation of DHCP and DNS settings in different areas of DNA-C. We mainly segregate our network between Corporate and Guest Traffic as a gross simplification. This is our main VN segregation. We have separat...
-
-
-
-
This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC! We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community
-
Forum Posts
Hi,I have an SDA multisite deployment that currently consists of two large fabric sites. Each fabric site has their own local internet breakout so IP transit has been configured from the fabric borders at each site to a local fusion switch which then...
I'm currently deploying two fabric sites for two large campus locations that will each have IP transit handoff to a local fusion switch for access to shared services and the internet, and that will both be associated to the same SDA Transit for inter...
Hi,I have a DNA fabric network, consist of border routers and fusion, edge connected to borders:Edge1 --------- Border1-------Fusion1Edge1 --------- Border2-------Fusion2Borders have iBGP between them, Fusion1 and Fusion2 have iBGP as well,Behind edg...
Sorry for the dummy question,I'm on the way to install the DNAC VM (from OVA) with 4 interfaces. At certain moment I'm asked for the cluster IP address.I tried (at the beginning) both Create MKS / Create MKS Non seed, still it seems the installation...
We have topology where ISR router is deployed with two links configured on L3 port and L2 port used for switching functionality...in case any of the L3 port gets faulty...can we use L2 port to perform functionality of L3 in SDWAN the way we use in tr...
Hi.I have main_office1 and main_office 2. My DNA border switches located on main_office1.Edge switches of main_office1 connect to border node 1 and bordernode 2 . and works fine.I connect new device (main_office_2_intermediate_node) that same model o...
Hi,As part of our SD-Access roll out, we wanted to keep some functionality we had on our legacy Cisco network where access to the management interfaces of our Fabric switches is locked down to certain remote addresses and the address of DNA-C. Though...
Just picked up my backpack and tshirt...Where are y'all staying? Mandalay Bay is crowded so bad... Vegas is hot as hell & bunch of weird looking people as always.
Resolved! L3 Handoff and LAN Automation
Hi!In my test environment, I'm deploying a C9500 as Border Node, connected to a Fusion Router (C9300) and a C9300 as the edge device.I did LAN Automation with the Fusion Router as the seed.The process went as expected, the C9500 and the C9300 were di...
Resolved! LAN Automation fails when stopped
Hi,I've bee trying to get LAN Automation to work, but I'm running into some issues.I have 2 C9500 that are connected via trunks to a pair of C6800 in a VSS. They have a VLAN configured, with an IP address, that is used for management.I use one of the...
Resolved! Cisco SDA Transit Control Plane
What is the recommended hardware to run the Transit Control Plane functionality? We may have several sites in a MAN topology and would like to connect them via SD-Access Transit. Curious what is recommended for production hardware for Transit Contr...
How do you configure a span port on an SDA router? C9500Thanks.
Hi all,I installed application policy so I could configure QOS within DNAC. All was complete and the app policy section was showing but after leaving for an hour and coming back to it I can no longer see it as an option and cannot amend my config..Wh...
