SDA Fabric Configuration in Layer 2 setup
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-14-2023 02:45 AM
Since I am new to SDAccess fabric world just putting up a weird question. Is there by any means we can run a SDA fabric in a layer 2 setup (by configuring the different IP pool subnet's gateway in a L3 switch or firewall outside the fabric).
- Labels:
-
SD-Access
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-14-2023 03:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-14-2023 03:44 AM
For that one you do not need SD-Acces you can setup traditional way and and have over to border node in SD-Access.
SD-access Fabric more of combination of Underlay - Overlay and using VXLAN to fix some limitation in exiting archtechture.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-04-2023 01:18 AM
Thank you.
