Dell storage with Cisco MDS 9500
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-14-2015 11:37 AM
HELLO guys,
I have one question regarding configure dell storage with Cisco MDS 9500 , that I plan to configure NPIV from dell storage and configure F port from MDS , but unfortunately the NPIV port that was created from storage not come up with MDS configuration if I configure NPIV from storage should I configure " F" port from MDS or there is any configuration I missed it
Please advice if any one know how the setup
Regards,
Ayman
- Labels:
-
Storage Networking

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-14-2015 01:37 PM
storage arrays do not understand NPV nor NPIV so i am not sure what you are referring to as far as you Dell array is concerned. Storage array login as F port and for that you don't need to do anything special on the switch.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2016 08:07 AM
thank you dynamo
