01-05-2015 07:16 AM
Hi all,
Can anyone tell me how Fabric Manager does its discovery of the SAN fabric and is there a command line equivalent e.g. equivalent to CDP? I need to make a network map of the switch connectivity if possible?
thanks
Chris
Solved! Go to Solution.
01-05-2015 08:01 AM
Hi Chris,
I usually use ...
For switches with Domain ID's:
show fcs ie (gives all switches with domain id's in the vsan)
Loc = Local (this switch)
Adj = Adjacent (directly connected and in the output of 'show topology')
Rem = Remote (more than one hop away)
show topology (gives ISLs for E_Ports)
show fcns database | i npv|VSAN (lists npv switches their fcid and VSAN)
show fcns data fcid <fcid> detail vsan x (lists the switch and interface at the bottom)
For NPV switches:
show npv flogi
The right hand side of the output lists the upstream interfaces
Regards,
David
01-05-2015 08:01 AM
Hi Chris,
I usually use ...
For switches with Domain ID's:
show fcs ie (gives all switches with domain id's in the vsan)
Loc = Local (this switch)
Adj = Adjacent (directly connected and in the output of 'show topology')
Rem = Remote (more than one hop away)
show topology (gives ISLs for E_Ports)
show fcns database | i npv|VSAN (lists npv switches their fcid and VSAN)
show fcns data fcid <fcid> detail vsan x (lists the switch and interface at the bottom)
For NPV switches:
show npv flogi
The right hand side of the output lists the upstream interfaces
Regards,
David
01-06-2015 05:46 AM
Hi,
Thanks, thats the sort of info I'm after!
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide