Hi Experts ,
We are trying to upgrade our nexus switch from 5.2(4) to 6.2(2a) through upgrade procedure. While installing the image we are getting the below error ,
Notifying services about system upgrade.
Show tech brief will take 4-6 minutes to complete. Please Wait ...
writing reset reason 16, aclmgr hap reset
NX7 SUP Ver 3.22.0
Serial Port Parameters from CMOS
PMCON_1: 0x200
PMCON_2: 0x0
PMCON_3: 0x3a
PM1_STS: 0x101
Performing Memory Detection and Testing
Total mem found : 8192 MB
Performing memory test... Passed.
NumCpus = 2.....
......
And the active supervisor engine reloads automatically and the failover is happening.And below is the show system reset commnad output
Reason: Reset triggered due to HA policy of Reset
System version: 5.2(4)
Service: aclmgr hap reset
There is no active config session , no stp changes , no inactive acl config , but still it fails. We have one more standby nexus switch with same model and Image . There, the upgrade was successful.
Please let me know if there are any clues on this.
Regards,
Vijay