Hi Experts ,   we are receiving the below logs often in our switch , %C6KENV-4-MINORTEMPALARM: XDB 1/0 inlet temperature crossed threshold #1(=70C). It has exceeded normal operating temperature range. Model: WS-C6506-E IOS:s2t54-ipbasek9-mz.SPA.150-1.SY4.bin   Modules:WS-X6908-10G ,WS-X6848-SFP,WS-X6908-10G ,WS-X6848-GE-TX , VS-SUP2T-10G   module 1:   module 1 power-output-fail: OK   module 1 outlet temperature: 66C   module 1 inlet temperature: 51C   module 1 asic-13 temperature: 79C   module 1 asic-14 temperature: 81C   module 1 EARL outlet temperature: 47C   module 1 EARL inlet temperature: 45C   module 1 EARL device-2 temperature: 84C   module 1 XDB outlet temperature: 72C   module 1 XDB inlet temperature: 71C   Kindly suggest.       ... View more

Hi Experts,   We are having 5508 WLC with 3602 AP model. Out of 250 AP's , 80-90 AP's automatically going to admin disabled status for every reboot of WLC. After that we have to enable manually for all AP's.   We have upgraded the WLC to 7.6.130.0 . Still issue persists.   Any suggestions on this.   Thanks, Vijay ... View more

Hi Experts ,   We are going to use interface level redundancy using "backup interface" feature in the router. I am able to do all the configuration , except GLBP virtual ip address , I am getting the below error   % Address 192.168.1.1 in group 100 - interface FastEthernet0/0   Router Config:   Interface Fa 0/0 backup interface fa 0/1 ip address 192.168.1.2 255.255.255.0 glbp 10 ip 192.168.1.1   Interface fa 0/1 ip address 192.168.1.2 255.255.255.0 But not able to configure the GLBP VIP.   Any suggestion on this.   Thanks, Vijay ... View more

Hi Experts ,   We have two 5508 WLC with 7.6.130.0 code and 700 AP's in flex connect mode for one SSID. We have registered 350AP's to WLC1 , and secondary controller as WLC2, For remaining 350AP's primary as WLC2 and secondary as WLC1. We have done AP level vlan mapping in the flex connect configuration.  We dont have any flexconnect group configuration in both  controller.   We are having issue like , the AP's flex connect vlan is automatically changing to WLAN interface vlan id when it is failing over to WLC2 , and even after the AP is came back to WLC1 the vlan is still WLANs interface.   So , is it necessary to configure flexconnect group in both WLC's to avoid this issue?   Thanks, Vijay.   ... View more

We were using ACS 3.3 and winows 2003 AD server previously for authentication and we were using NAR in ACS for limiting the wireless users to a SSID.   Recently we have migrated with windows 2008 R2 AD server . Now , Network access restriction is not working as expected . Kindly suggest . ... View more