Removing Interop Mode 1

[DavidSAnderson10]

I need to disable Interop Mode 1 after retiring McData switches. Can someone tell me what is the cli sequence to return the MDS 9000 series to default/native interop mode?

Thanks in advance!

[chunkmunky]

Did you set Interop Mode on a specific VSAN?

[tblancha]

do these commands for vsan X:

config t

vsan database

no vsan X interop 1

This will put it back in default mode.

[chunkmunky]

After running the command against the vsan won't you have to suspend it to make the change active.

[donhoover]

At one time, there was a white paper that went through a detailed migration of McData -> Cisco, including adding Cisco to the SAN in interop mode 1, and removing the McData.

I can't find it at the moment though.

[DavidSAnderson10]

I used these commands then suspened the vsan.

Worked fine.

Thanks all.