07-16-2013 08:10 PM
Hello every one !
I`m a Network guy and I think I`m a fresh for storage. I`m config a FCoE link on Nexus 7000,but there is something wrong and I need some help from you !
==============================================================================================
Problem:
1. I can built a storage VDC , but I can`t enable " feature fcoe " , but "feature-set fcoe" is okay
2. when cheak interface status ,It appear :
xxxxxxxx# show int e3/39
Ethernet3/39 is down (Internal-Fail errDisable, fcoe_mgr: ethernet interface module is not licen)
===============================================================================================
my software version is 6.1.2 and line-card is N7K-F248XP-25E ,and is my license:
xxxxxxxx# show license usage
Feature Ins Lic Status Expiry Date Comments
Count
--------------------------------------------------------------------------------
MPLS_PKG Yes - Unused Never -
STORAGE-ENT Yes - Unused Never -
VDC_LICENSES No 0 Unused -
ENTERPRISE_PKG No - Unused -
FCOE-N7K-F132XP No 0 Unused -
FCOE-N7K-F248XP No 0 Unused -
ENHANCED_LAYER2_PKG Yes - In use Never -
SCALABLE_SERVICES_PKG Yes - Unused Never -
TRANSPORT_SERVICES_PKG Yes - Unused Never -
LAN_ADVANCED_SERVICES_PKG Yes - In use Never -
LAN_ENTERPRISE_SERVICES_PKG Yes - Unused Never -
--------------------------------------------------------------------------------
=================================================================================================
It is a license problem ? Please help me ,Thanks Very much!
Solved! Go to Solution.
07-19-2013 11:43 PM
I think you can use the grace license first to ensure your configuration will run correctly.
issue command license grace on the N7K, and then try to enable the fcoe license on the F module (license fcoe module x). The FCoE only run on the F module. If use F2 module, you must have sup 2.
Thanks
07-18-2013 08:53 PM
Please confim below things.
1. On the switch make sure that fcoe feature-set is isnatlled -
install feature-set fcoe
2. Make sure that, you have allowed fcoe feature-set for the storage vdc
conf t
vdc
allow feature-set fcoe
3. Make sure that the module you are using is licensed for FCoE
conf t
license fcoe module
Hope this helps.
-Ganesh
07-18-2013 10:24 PM
Thank you for your answer !
I have installed feature-set and allow it in storage VDC , but when I license fcoe module
switch(config)# license fcoe module 3
ERROR: FCOE License not available XXG_Nexus7004(config)# license fcoe module 3
ERROR: FCOE License not available
Does it mean I have no license for module ?
07-18-2013 10:37 PM
Yes, looks like you don't have the FCoE license installed on the switch. Could you please check if you have FCoE License installed using the command, show license file
This would show what kind of license each file is and hence you can check if you have one for FCoE.
-Ganesh
07-19-2013 11:43 PM
I think you can use the grace license first to ensure your configuration will run correctly.
issue command license grace on the N7K, and then try to enable the fcoe license on the F module (license fcoe module x). The FCoE only run on the F module. If use F2 module, you must have sup 2.
Thanks
07-20-2013 12:40 AM
Thanks for all !
I will try later and find out what the problem is , Thank you for all resolves above !
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide