The FC Cisco Switch is not recognizing the SFP from storage

[P.manhique]

I am trying to connect a  SAN switch to a storage but the  Switch is not recognizing the SFP from storage. Are there any compatiility issues?

Details of the storage SFP:

Model Cisco Tyco

Model of Switch: MDS9148

[Walter Dey]

Don't understand; do you have problems with the SFP on the MDS, or the peer side on the storage controller side ?

https://supportforums.cisco.com/discussion/12736436/cisco-5548-version-52-equivalent-command-service-unsupported-transceiver

[P.manhique]

I am having the problem at the MDS side. Below is the error i am having:

fc1/13 sfp is present but not supported

    Name is CISCO-TYCO

[P.manhique]

fc1/13 sfp is present but not supported

    Name is CISCO-TYCO

    Manufacturer's part number is 1-2053783-2

    Revision is T

    Serial number is TED1923B5HS

    FC Transmitter type is Unknown(0)

    FC Transmitter supports Unknown(0) link length

    Transmission medium is Unknown(0)

    Supported speeds are - Min speed: -1 Mb/s, Max speed: -1 Mb/s

    Nominal bit rate is 10300 Mb/s

[Walter Dey]

Looks odd ! nominal bit rate 10300 Mb/s ! this is 10G !

MDS 9148 is a classical FC switch ? 

[P.manhique]

Yes it is..!!

[dakester]

Hi,

part number is 1-2053783-2

type is SFP-H10GB-CU3M

This is a copper 10G Ethernet cable.

Use one of these SFPs:

Cisco MDS 9000 Family Pluggable Transceivers Data Sheet

Regards,

David

[Walter Dey]

Are you sure this is a FC SFP ? 4, 8 G ?

If yes, try to use the "service unsupported-transceiver" which is a hidden command (type the full command, no abbreviation).