06-25-2014 04:59 AM
hi every one ,,
i have a switch 4503 E with the following modules installed on it :-
Mod Ports Card Type Model
---+-----+--------------------------------------+------------------+-----------
1 2 Supervisor II+ 1000BaseX (GBIC) WS-X4013+
2 18 1000BaseX (GBIC) WS-X4418-GB
and i need to upgrade this modules to :-
( i'll change module number 2 and install 2 modules of the following :
2 X WS-X4606-X2-E Catalyst 4500 E-Series 6-Port 10GbE
my question is : do i have to change any thing else in the switch to accomplish this task ( do i have to change the Supervisor II module ) ?
Solved! Go to Solution.
06-25-2014 08:28 AM
Hello, TamerAlDeeb2.
The WS-X4606-X2-E is supported on Supervisor Engine e 6-E, Supervisor Engine 6L-E, the Supervisor Engine 7-E, and the Supervisor Engine 7L-E. Supported chassis are Catalyst 4503-E, Catalyst 4506-E, Catalyst 4507R+E, Catalyst 4507R-E, and Catalyst 4510R+E switch chassis.
You can install it on any slot as long as it is not a supervisor engine slot, of course.
Please send me an e-mail (adawa@cisco.com), if you have additional concerns or need more support. Kind regards.
06-25-2014 08:28 AM
Hello, TamerAlDeeb2.
The WS-X4606-X2-E is supported on Supervisor Engine e 6-E, Supervisor Engine 6L-E, the Supervisor Engine 7-E, and the Supervisor Engine 7L-E. Supported chassis are Catalyst 4503-E, Catalyst 4506-E, Catalyst 4507R+E, Catalyst 4507R-E, and Catalyst 4510R+E switch chassis.
You can install it on any slot as long as it is not a supervisor engine slot, of course.
Please send me an e-mail (adawa@cisco.com), if you have additional concerns or need more support. Kind regards.
06-25-2014 12:44 PM
Thank you adawa very much for reply ,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide