After some time can't get access to SG200 via WEB interface (management address).

[smarts_09]

Hello !

May be someone faced with following problem:

I have just upgraded my SG200-26P up to 1.4.1.03 version.

When SG200 just started it works OK and no any problems but after some hours I can't get access Web interface via mangement address.

I can't ping it at all :((( And only reboot switch help me to restore connectivity.

I will appreciate for any ideas.

[Glenn Martin]

How many SG200's do you have?

Was this issue experienced prior to the upgrade?

Did you remove all configurations and start over?

[smarts_09]

Hello Martin !

I have one SG200-26P and we have just bought another one SG200-26FP but have not installed it yet.

No, I had not this issue before firmware ugrade.

I had FW version 1.1.2.0 and 3 days ago I made FW upgrade to 1.4.1.03.

Yesterday I rebooted SG200 a few times due to problem with access to web interface though I could ping my management address.

The main problem that SG200 is located 400 km from me and access to SG200 is very sensitive for me. It's a pitty that SG200 don't have console port. So, as my colleague was near SG200 yesterday I was able to reboot it using my colleague. Eventually I made downgrade FW to previos release v.1.4.0.88. And it still works fine.

[smarts_09]

Hello,

We installed antoher one SG200-26FP. It was upgraded to 1.4.1.03 as well. But it's working without problem with current firmware.