Switches - Small Business

I use SG300-10PP 10-Port Gigabit PoE+ Managed Switch connect to cisco ap 3602ithe switch alway provide 7-9 watts.the power not enough for this apI cannot config it to provide more than 9 wattsplease help me to verifythe firmware is lastest Firmware V...

Hi,The situation is I have an SG500-28 configured as L3 with multiple VLANS and their respective DHCP servers enabled. However, mobile devices particularly mobile phones cannot connect to the network via WiFi. Laptops have no issue connecting via Wif...

Hi all, I have a problem with the stacking of 2 SG500X switches. I need to be able to use the 5G Stack ports to stack the switches, so XG1 to XG4 stay network ports.Is that possible? I can't find anything about this sort of config.Please advise. Rega...

We have several locations where there is still IBM Cabling in the walls.  These locations now get new Cisco SG500 switches. Is there any documentation about the use of this cable (2-pair twisted pair with 150 ohm characteristic impedance) with the Sm...

I've been doing CLI for a long time now so I'm new to the GUI for the SG200 switch. I want to create two VLANs and assign both of them different ip addresses. How do i do it in a SG200 switch?

Hi all. As I see, last update for SG units came in late June so it doesn't includes the latest openssl versions that got released a week ago. These versions patch severe vulnerabilities. I avoid using web interfaces but in SG units sometimes CLI is k...

Hello everyone, I have a Cisco Small Business 8-Port Gigabit Smart Switch (SG 200-08) which I purchased to put into a site that has a few other Cisco 200 series Small Business switches etc. All the switches on this site are running the latest firmwar...

I have a UniFi WAP that I'm fine getting it set up on the default/native vlan1 with the smart ports left to the default settings but as soon as I move the thing over to a port with a vlan it can't associate and everything goes down hill from there. D...

Dear all,we installed a new switch SG200-26P at customer side. It is connected as uplink to an existing SF200, with which they had no issue at all. Configuration is exactly the same.SG200-26P has the latest firmware 1.4.1.3 and boot 1.3.5.6.Sadly, it...

Hello,I have a Cisco SG300-10PP switch.  It has become convinced that the voice VLAN should be 64 and I cannot disabuse it of that notion.  I have reset it to factory defaults and it still thinks this.  I have manually set the voice VLAN ID to 68, wh...

Hi allWe need to  upgrade the SG300 managed switch to act as a L3 Switch. We want to create two vlan on the switch as follows1. LAN 172.16.16.0/242. Guest 172.16.20.0/24Send the traffic to the gateway on the UTM by static route.we want to connect the...

hiI have a srw2048 switch but problem is I need password to enter setup menu which I do not haveI have checked manual & it mentions if you connect to switch with supplied null modem cable to console port & HyperTerminal & hit enter/escape key just af...

I have two new SG500-28 POE switches I need to setup for a new floor implementation. If possible I would like to copy the config of same model switch I have in production to these new switches and then login and make a couple of changes (name, IP add...