Cannot change mangement VLAN on an SG300-28MP

[bdgarcia]

Firmware 1.3.7.18.   I have used many SG300-10MPPs and I have never experienced this issue with any firmware version.   I have defined VLANs 1, 100, 101, and 999.   I am trying to change the management VLAN from 1 to VLAN 999.

Any help is greatly appreciated.

Thx

Bryan

[cheveret]

Hello Bryan,

You will need to set a port to have VLAN 999 on it as a tagged or native VLAN. You can do this by navigating to VLAN Management > Port VLAN Membership and setting the port tagging appropriately. After that, you can navigate to Administration > Management Interface > IPv4 Interface  and you should be able to set the management VLAN to 999 and set the appropriate IP address for that VLAN.

Let us know how it goes.