Cisco SG200-8 web interface not working

[doug.simpson]

Good day!

I have a Cisco SG200-8 Smart Switch and I need to get into it to mirror some ports.

The default address is supposed to be 192.168.1.254 and I have the computer(s) (I've tried several) configured for the proper network address and mask.

No ping, and I can't access it with the web interface.

Did Cisco change the default address and not tell anyone or something?

I have tried the reset button, short to restart it and long to reset it to factory all to no avail.

Any assistance would be greatly appreciated.

Doug

[Zach S]

Doug,

This earlier forum posts might cover what you are trying to accomplish.

https://supportforums.cisco.com/discussion/11274576/unable-get-web-interface-sg200-18

[ghostinthenet]

If you have an existing DHCP server on the network, the SG200 will try to get a dynamic address before falling back to 192.168.1.254. I would look at the MAC on your switch label, check your DHCP server and see if you have a binding for it there. If you do, that's where you need to point your web browser.