Morning all,
Having some issues with my Sophos XG firewall adopting APs. I have narrowed it down to the config on my smart switch (SG500-28P) as it will work with a dumb switch that I connect to it and my firewall can see the AP.
The network is flat, with a few different cisco switches in the mix. I have successfully connected and adopted a few other APs via a netgear switch.
So, my question, is there any specific config I should be selecting on my SG500 to allow the APs to be seen and adopted? I can see power being used on the POE ports so know they are connecting. I had assumed (perhaps incorrectly) that the Smartport setup would detect the device and adjust the port settings appropriately. Any help would be great.
Rich