Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
2117
Views
0
Helpful
1
Replies

Configuration problem with SGE2010-G5

oosterom
Level 1
Level 1

‎05-31-2010 03:06 AM

Hello,

i've recently bought a SGE2010-G5 48 Ports Workgroup switch. The first thing I did was to give the device a static IP Address, 131.237.95.253, with the default gateway 131.237.95.254. Than I used a webbrowser to configure the switch, which included an upgrade to the latest firmware (3.0.0.18). After a reboot (to activate the latest firmware), the IPV4 settings were gone , and also the users that I've created, so I had to start all over again. Also I'm affraid that after a power failure I have to configure all settings again, because it looks like the settings are not stored permanent.

Does anyone recognise this problem?

Regards,

Michel Oosterom

Labels:
0 Helpful
1 Reply 1

oosterom
Level 1
Level 1

‎05-31-2010 05:16 AM

I just saw the option to save files from running-config to startup-config.  After saving the running-config to startup-config everything worked fine after a reboot.

0 Helpful
Customers Also Viewed These Support Documents