Configuring the SF300 for multiple VLans with DHCP enabled

[dreebs78]

I am trying to setup a network that will have multiple VLANS with DHCP and some of the VLANS would be broadcasted through a wireless controller to some APs.  The APs would have multiple SSIDs that are each linked back to one of the VLANS.  My question is how do i setup the SF300 side of the network to have multiple Vlans that have dhcp from the switch plus allow some of the vlans to be on a wireless network?

[mihail_ip]

Hello Dreebs,

Just configure the port 8 as Trunk (it is by default) and add all your vlans (10, 20, 30, 40) to that trunk

On controller side I suppose it should also be trunk and contain the same vlans (10, 20, 30, 40) 

Hope it helps

Regards,

Mike