Switches - Small Business

Hello,I have questions about managing Cisco licenses, especially the Catalyst 9X00 switches.My network is in a confined area, my questions are: 1. Is it possible to install custom long-term licenses (3 years or 7 years) on my switches before integrat...

Hello i have a cisco sg200-10fpand system led blinking after factory reset always with no acess can you helpether ports are on after a while 

I have a SG300-52MP taken off a site as PoE has failed on the device, how do I go about requesting RMA for this small business switch?

Dear ALL, We are using cisco small business SG 350 52 port Switch. We are using voice and data service and configrue the native vlan on ports and port type is trunk. We are facing the problem when switch gets restart it's lost the native vlan and rem...

HelloDoes anyone have a SRW2024P. If so can you make a backup copy of the boot.bix file and attach it. I have messed up and afraid to reboot the switch. Please help.

We are in the process of upgrading our phone system to a NEC SV9100 with IP phones. I plugged a phone in (PBX not online) to do some initial configuration on the phone with the following:SG550X-48MP with newest firmware (2.4.5.71)NEC DT800 series pho...

We just upgraded our Sg300 series switches to the new IOS so we can get CLI access. The upgrade went fine but it seems we have two login prompts, the first being completely unnecessary as you can just hit return to get by it. IE here is the progressi...

Having an issue with two SG250-26HP switches.  When I assign VLAN 1 a static IP address, I lose the GUI and ability to ping it from outside the LAN.  If I revert back to DHCP, the GUI comes back and I can again ping from outside.  Is there a security...

Hi Brandon, I am having a hard time figuring out the configuration for "Voice and data vlan implementation with DHCP for both the vlans on SG-220 26 PORT SMART SWITCH". I tried to implement as it works on other cisco switched. But the command and the...

I have a tenant that wants to install 10 ea. of the Cisco C9300-48P-E switches in a small storage room. Could you please tell me the heat dissipation(cooling load) in BTU/Hr per switch. I am concerned about the heat buildup in the storage room, I mig...

I have a Cisco Catalyst 9200L 48 PoE 4 x 10GB Switch. I want to secure the power and need information for this switch if the electricity drops. Any advice on how much power this model needs during a power outage? Europe as a location. Thank you!  

HiHave a small closed network used for IPTV and the players are being assigned IP's via DHCP on the core switch. I then have two edge switches that are configured as relay's. This seems to work fine to start with. After a reboot or sometime the clien...

This is really strange. I just had ATT leave after checking my Fiber. When plugged directly into the back of my router my Internet speeds are 935MB When I go through my Cisco switch I get 86mb. Its like my switch is dropping the speed down to 10/100....

Hello,I have a question. I am able to configure DHCP for Vlan on Cisco 2960G switch (internal network purpose). Can I do the same for Cisco 4948E switch? Is Cisco 4948E switch support DHCP server? Thanks,Tommy