Difficult to find MIB CPU utilisation Switch - model CBS250-8T-D

[LeoShq]

Hello guys, i spent 1 day but i cannot find the MIB for cpu utilisation. Some could help me ? 

I use all snmp walker tool (even the cisco one) but did not help me. 

I've shared screenshots below to get an idea of ​​what parameters I'm looking for. Thank you !

[Kasun Bandara · Accepted solution]

@LeoShq check below articles if that helps.

https://community.cisco.com/t5/switches-small-business/do-we-have-mib-oid-value-to-monitor-snmp-the-cpu-load-of-the/m-p/2591768
https://www.cisco.com/c/en/us/support/docs/ip/simple-network-management-protocol-snmp/15215-collect-cpu-util-snmp.html

[ammahend]

have to tried these ?

• Five Seconds CPU Utilization:

  • OID: 1.3.6.1.4.1.9.2.1.56
  • Description: Represents the CPU utilization for the last 5 seconds in percentage.

• One Minute CPU Utilization:

  • OID: 1.3.6.1.4.1.9.2.1.57
  • Description: Represents the CPU utilization for the last 1 minute in percentage.

• Five Minutes CPU Utilization:

  • OID: 1.3.6.1.4.1.9.2.1.58
  • Description: Represents the CPU utilization for the last 5 minutes in percentage.

[LeoShq]

Thanks for the replies @Kasun Bandara  @ammahend .

After a lot of hours of searching, the OIDs are inside the MIB called CISCOSB-rndMng.  

1.3.6.1.4.1.9.6.1.101.1.7 last second

1.3.6.1.4.1.9.6.1.101.1.8 last minute

1.3.6.1.4.1.9.6.1.101.1.9 last 5 minutes

Thanks. 

Kind Regards,

Leonardo.