firmware upgrade failed on linksys-cisco WRV210 router

[bazistanar]

After a Linksys-Cisco WRV210 firmware upgrade I can't reach the configuration surface by any browsers. I can ping the 192.168.1.1 address successfully, but a can't configure the router. I tried the to use the reset bottom without any success.

Thank's for suggestions to solve the problem.

Zoltan Kocsis

[Philip D'Ath]

Have you tried both http and https?

I assume you don't have a proxy server configured in your browser.

[bazistanar]

Yes, I'v tried both, and no proxy server.

I'm almost sure, that the firmware upgrade has failed. The question is: is there any possibilities to perform the firmware upgrade, without using the built in configuration software of the router?