03-29-2016 11:40 AM
After a Linksys-Cisco WRV210 firmware upgrade I can't reach the configuration surface by any browsers. I can ping the 192.168.1.1 address successfully, but a can't configure the router. I tried the to use the reset bottom without any success.
Thank's for suggestions to solve the problem.
Zoltan Kocsis
03-29-2016 06:32 PM
Have you tried both http and https?
I assume you don't have a proxy server configured in your browser.
03-30-2016 02:19 AM
Yes, I'v tried both, and no proxy server.
I'm almost sure, that the firmware upgrade has failed. The question is: is there any possibilities to perform the firmware upgrade, without using the built in configuration software of the router?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide