Switches - Small Business

I have two servers, both with SSD drives, copying large files using the 10 gb SFP ports on this switch.  However, network performance seems to be poor.  I typically see 1 - 2 gbps of throughput.  What might be some reasons for low throughput?

Hello, I need to disable sticky mac on a range of ports. What would be the proper command to do so? Thanks

Hey All, Bit of an issue I'm having at the moment.  Have an SG300 in my network, which works fine with multiple VLANS and routes working as expected.  I just introduced another SG200 into my network, which I know isn't layer three, to support some P...

Onlye file can find it's sx200_boot-13506.rfb Can not upgrade from Sx200 Firmware Version 1.3.2.2 to Sx200 Firmware Version 1.4.0.88  very frustrating

For the 500 series family, can i mange the 500 series family through prime 3.0 or not ? if yes what choice should i choose through CCW ? 

Hi, I am having an issue with Cisco Switch SG200-50p. IP Phones on Voice VLAN have connectivity, but PC on data vlan do not have connectivity. On the logs of the switch I see this error:  %CDP-W-NATIVE_VLAN_MISMATCH: Native VLAN mismatch detected on ...

Got a weird issue I set my ports on my SG500 switch to trunk and a tagged my voip vlan and set my native vlan, I also enabled QoS for the VOIP. Recently we upgraded to a 100Mb internet service and when testing the speed I was only seeing 30-40Mb down...

Hi. I had task to reload 4507 switches that using HSRP. Anyway after the task, we compared with before running configuration and after running configuration. Then we find something strange thing. When we typed sh run command, we saw like below snmp-...

Have a (4) switch stack of sg500-52p switches.  Once the stack comes online, I can view mac addresses in the dynamic table.   Eventually at some point attempting to view the dynamic mac addresses shows a blank table on the web interface.  If I SSH in...

After a Linksys-Cisco WRV210 firmware upgrade I can't reach the configuration surface by any browsers. I can ping the 192.168.1.1 address successfully, but a can't configure the router. I tried the to use the reset bottom without any success. Thank's...

Scenario or Setup: I have 3 x 3750 switches with 3 VLANs voice data and wireless. I also have a controller connected to the switch fabric i have 3 APs working and joining the controller. ISSUE:I have an AP that has to be connected to a small office...

I am trying to update the boot code and firmware on my SG300-20 and SG300-28P.  I deactivated Windows Firewall, Glasswire and Malwarebytes.  I acquired TFTPD64 and extracted it to the C drive in its own folder.  I downloaded the 1.4.1.03 ZIP, extract...

Hi I am trying to assign static ip adddress on vlan 1 interface , the model no of switch is SG300 & the firmware version is 1.1.2.0 .But whenever I type the IP address & press enter , a  question is popped up asking for confirmation (switch0d851f(con...