03-15-2018 10:37 AM - edited 03-21-2019 11:22 AM
Hi Team
I have been asked to configure Cisco SG500 switch with initial setup. I did complete the configurations except for stack ip address.
Need support how to configure stack ip address to switch.
Thanks
Srinivas Patnaik
03-28-2018 05:48 AM
03-28-2018 06:42 AM
07-31-2018 09:14 PM
In order to change Management IPv4 Address please go to IP Configuration ---> Management and IP Interfaces ---> IPv4 interface, once you're there you'll find two interfaces on VLAN 1, one of them is DHCP and the other one is Static, please delete the DHCP one, then add a new interface with IP address type as Static, enter the new IP address you'd like to use, enter the Network Mask and then apply the changes.
As soon as you apply the changes you'll lose connectivity with the switch because the new IP address will be applied, in order to regain access just try to access the GUI using the new IP address you entered in the previous step and you should be able to access it just fine.
You can make sure the new configuration has been applied by checking the IPv4 Interface Table.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide