Is SG200-50P able to be an IGMP Querier?

[aarblaster]

Hello,

I'm looking for some information on the SG200-50P Smart Switch. I can't find the IGMP Querier stetting on these switches. From the information on the product pages it looks as if it should be in Multicast -> IPv4 Multicast Configuration -> IGMP Snooping and then the per VLAN setting pop up from the same page.

I thought perhaps this was a firmware problem but the switches are all on the latest version (v 1.4.11.5).

Any advice or clarity would be appreciated.

[marce1000]

  - Not sure , if it can do it ; checkout : https://community.cisco.com/t5/online-device-emulators-small-business/bd-p/911-discussions-online-device-emulators
                 https://www.cisco.com/assets/sol/sb/SG200_Emulators/SG200_Emulator_v1-2-9/config/home_SG_200-50P_1_2_9.htm
           I found something similar in  Multicast -> IGMP Snooping , not sure if that is what you need , 

 M

[aarblaster]

Thanks @marce1000 – doesn't clear things up, but I didn't know that's where the emulators were. That's super helpful anyway.

Hope you're having a great weekend.

A