Management IP address change issue on SF/SG350 models

[George Rodriguez]

There appears to be a bug in the gui for SG/SF 350 models where once the management ip address has been changed to static and assigned a new one it cannot be changed in the gui.

The CLI allows the change though.

I dont have smartnet on any of the switches so I'm hoping someone from Cisco monitors these threads and can report the issue.

BTW, i have th elatest FW loaded.

[jigthaku]

Hello George,

My name is Jigar Thakur from Cisco TAC.

Kindly follow the below link to change the management IP address of SG350 switch through GUI.

https://sbkb.cisco.com/CiscoSB/GetArticle.aspx?docid=2541144f266f47158b60d57b7defb04a_h_5241.xml&pid=2&converted=0&offline=0

Thanks and regards

Jigar Thakur

[George Rodriguez]

This link is not helpful.
The gui nor the CLI will allow me to change the IPV4 Management IP address to another IP within the same subnet.
I have worked with the 300 series and there is no issue it appears to only be an issue on the 350 series.
I found a workaround on the forums that works but we shouldn't have to resort to a workaround.
This is the link to the workaround.
https://community.cisco.com/t5/small-business-support-documents/setting-static-ipv4-address-on-a-switch-using-gui/ta-p/3396718
Thank You.