cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3195
Views
0
Helpful
2
Replies

Monitor CPU utilization in PRTG for SG200 and SG300 switch series

Boris Bahes
Level 1
Level 1

I'm trying to setup PRTG to monitor CPU Utilization on Cisco SG200-26, Cisco SG300-10SFP and Cisco SG200-18 for period of one month.

However I'm unable to figure out which MIB to load into PRTG to get this statistics?

I have downloaded MIBs_Sx200_v1.4.1.03 and when I load CISCOSBCpuCounters.mib I don't get any numbers.

Can someone advise which MIB's should I use?

Many thanks!

1 Accepted Solution

Accepted Solutions

Michal Bruncko
Level 4
Level 4

Hi

you can use following OIDs to get CPU utilization:

CPU utilization for 5 seconds
.1.3.6.1.4.1.9.6.1.101.1.7.0
CPU utilization for 1 minutes
.1.3.6.1.4.1.9.6.1.101.1.8.0
CPU utilization for 5 minutes
.1.3.6.1.4.1.9.6.1.101.1.9.0

View solution in original post

2 Replies 2

Michal Bruncko
Level 4
Level 4

Hi

you can use following OIDs to get CPU utilization:

CPU utilization for 5 seconds
.1.3.6.1.4.1.9.6.1.101.1.7.0
CPU utilization for 1 minutes
.1.3.6.1.4.1.9.6.1.101.1.8.0
CPU utilization for 5 minutes
.1.3.6.1.4.1.9.6.1.101.1.9.0

Do these MIB variables depend on the firmware being used?

 

For switches I've upgraded to the latest 1.2 version of firmware, the above do not work:

 

Cisco Sx220 Series Switch Software, Version 1.2.0.3, RELEASE SOFTWARE

 

CISCO-SMI::ciscoSB.101.1.7.0 = No Such Object available on this agent at this OID

CISCO-SMI::ciscoSB.101.1.8.0 = No Such Object available on this agent at this OID

CISCO-SMI::ciscoSB.101.1.9.0 = No Such Object available on this agent at this OID