Hi,
Previously I was configure my switched successfully 6Mbps each port for my WAP client.
But I need few port config to customized.
Here I want to config 1 port for bandwidth rate 20 WAP x 6Mbps each WAP with MAC allow and deny for unauthorized access. Here i want to config my Cisco Switch
#1. Any MAC allow or deny incoming user's WAP from any Port to my Switched. 1 Port or all Port
#2. Config bandwidth for 1 port or many port which are equal rate 6x24=120 Mbps rate or custom bandwidth for 20 WAP User's. I need CLI command cmdlet.
#3 How to add Switch with those protocol PPTP, PPP, L2P and PPPoE username and password? GUI or CLI command
Please help me for configuration CLI Scripts,
Thank you very much.
Foysal