SEG 2010 switch

[djames]

We have a seg2010 48 port gigabyte switch.When I try to get into the switch through a browser the screen comes up blue. I have tried different browsers but I am not seeing anything. Is there another way to see the ports? I did connect through command line but don't know the command line command to see the ports. I have a patch panel that is labeled wrong and I need to see which port is connected to the port.

[stevebrandli]

Do you mean SGE2010?

If so, you can telnet to the switch.  After logging in, hit Cntrl-Z.  Type lcli.  This brings up the cli interface.  You can hit a question mark to see the commands you can type.  If you hit tab, it will command-complete.  You can type a ? at any point in the command and it will tell you the next options you have.

It takes some playing around and patience to learn the interface.  But you don't need a manual.