SG200-08 firmware issue

[RMBaltzer]

Hi,

I have upgraded my SG200-08 switches from firmware version 1.0.5.1 to version 1.0.6.2. Since that new firmware is active, the network-printing from my Macbooks and iMacs is not working anymore. They all have TCP/IP connected network printers (not based on Bonjour connections) and they cannot print anymore; timeout communicating to printer. Windows workstations on the same network are still able to print to the network printers, only the Mac's do have this problem.

I am still able to view printer-information via the Mac's, so communicating is still possible. Also surfing to the admin-page of these printers is still working, only sending the actual print-job is failing.

I have reset the SG200-08 switches to factory defaults, but still no printing.

Finallly I did a downgrade, back to firmware version 1.0.5.1 and now printing from the Mac's is working again.

Any ideas, perhaps a firmware bug?

I have seen the new firmware version 1.2.9.44, but there are only language files available for the SG200-08, no firmware file...

So I don't know if this new version perhaps solves this problem.

Kind regards,

Rene.

[mpyhala]

Christian,

There is not and will not be a Version 1.3.7.18 for the 8-port switch. Due to hardware limitations the 8-port switch is not capable of sharing firmware with the larger switches.

Version 1.0.7.4 is the latest version for your switch. If a new version is released for the 8-port switch it will likely follow the 1.0.x.x format, not 1.3.x.x.

- Marty

[colbrucisco]

Are you kidding me? I have installed the latest FW 1.0.8.3

And the problem is still there. I bought two SG 200-08 in 2016. And I can't print when using a Mac.

I am soooo disappointed of cisco. That was the last switch I ever bought from cisco.

Over and out!!