SG200-50P & SNMP temperature monitoring

[damian.woz]

Hi,

Is it possible to monitor SG200-50P temperature and FAN status (or each FAN RPM) via SNMP? If yes, which OID's are responsible for monitoring this?

[damian.woz]

Bump. Anyone knows?

[Aleksandra Dargiel · Accepted solution]

Hi Damian,

Those are for fan status. Have not seen the temperature yet but will try to verify and get back to you.

Fans Unit 1	.1.3.6.1.4.1.9.6.1.101.83.1.1.1.3.67109249
Fans Unit 2	.1.3.6.1.4.1.9.6.1.101.83.1.1.1.3.67109250
Fans Unit 3	.1.3.6.1.4.1.9.6.1.101.83.1.1.1.3.67109251
Fans Unit 4	.1.3.6.1.4.1.9.6.1.101.83.1.1.1.3.67109252

Regards,

Aleksandra

[damian.woz]

Thanks for answer. About temperature monitoring - I found something like: rl env fan data temp - The unit temperature - 1.3.6.1.4.1.9.6.1.101.83.5.1.1.2.1

Now I'm also searching for OIDs that can show me: total bytes RX / TX and RX errors on LAG interfaces.

[damian.woz]

So I also found RX Packets with Errors on LAG interfaces (which is iso.3.6.1.2.1.2.2.1.14.1000 - iso.3.6.1.2.1.2.2.1.14.1003).

I'm not 100% sure about this 2 OID's below:

RX Total Bytes on LAG if: iso.3.6.1.2.1.2.2.1.10.1000 to 1003

TX Total Bytes on LAG if: iso.3.6.1.2.1.2.2.1.16.1000 to 1003

Can anyone confirm whether this OIDs are properly?

[damian.woz]

Bump...

Can someone confirm if this RX/TX Total Bytes on LAG are properly (or not)?
 

[Aleksandra Dargiel]

Hi Damian,

I have not done LAB for this yet. But I would suggest you to call Cisco Small Business Support Team and they would be able to assist you:

http://www.cisco.com/c/en/us/support/web/tsd-cisco-small-business-support-center-contacts.html

Regards,

Aleksandra