01-22-2019 03:43 AM
hi guys,
during some testing of a SG550XG I`ve detected some questions, which I was`nt able to figure neither with the CLI nor the Admin Guide...
in the DEFAULT configuration there`re some lines which I do not understand (= because I´ve not build up a stack yet...):
unit-type-control-start
unit-type unit 1 network te uplink none
unit-type unit 2 network te uplink none
unit-type unit 3 network te uplink none
unit-type unit 4 network te uplink none
unit-type unit 5 network te uplink none
unit-type unit 6 network te uplink none
unit-type unit 7 network te uplink none
unit-type unit 8 network te uplink none
also the default port-channel interfaces I do not understand the purpose, why are they pre-configured?!
Ch Type Duplex Speed Neg control State
-------- ------- ------ ----- -------- ------- -----------
Po1 -- -- -- -- -- Not Present
Po2 -- -- -- -- -- Not Present
Po3 -- -- -- -- -- Not Present
.
.
.
would appriciate it, if someone could explain this to me :)
02-18-2019 06:44 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide