Hi All,
I have a problem similar to https://supportforums.cisco.com/message/3103915:
We use passwords with special chars, worked fine with fw 1.0.1.
I want to re-commission the switch, so before that, I upgraded to the latest firmware, 2.0.0.10. Since then, I'm getting "Invalid Username or Password.".
Tried with admin/admin, cisco/cisco, admin/<my old password>, combinations of these... still no good. Tried from different hosts, IE6, IE8, Fire, Chrome.
I'll have to reset it to factory config before I move it to it's new role, but that'll be a few months from now. I'd prefer to be with a usable GUI in the meantime.
Any ideas?
Thanks,
Tamas
