SNMP config

[emmens cisco]

guys,

sg200 is there step by step configuration snmp document.

[Jitendra Kumar · Accepted solution]

enable SNMP

1. Log into the switch’s web interface.
2. Click SNMP in the left-handmenu.

1. Click Communities.

1. Click Add.

1. Enter the IP address of the Auvik collector and the community string you wish to use.
2. Click the checkbox for Read Only. Click Apply, then Close.

1. Click Security in the left-hand menu.
2. Click TCP/UDP Services.

1. Click on the checkbox for SNMP Service, then click Apply.

1. Click Save at the top of the user interface.

[emmens cisco]

yes got it.