07-02-2010 08:58 AM
Title says it all....
How do you enable jumbo frames on an SRW2008?
The data sheet says it supports jumbo frames, but the manual does not say how to enable, and I did not find it in the Web GUI.
It just occured to me (light dawns on marblehead) - perhaps this needs to be done via the CLI?
TIA.
07-02-2010 11:19 AM
ADMIN --> Jumbo Frames (checkbox) on the GUI for the switch.
07-08-2010 05:57 AM
Title says it all....
How do you enable jumbo frames on an SRW2008?
The data sheet says it supports jumbo frames, but the manual does not say how to enable, and I did not find it in the Web GUI.
It just occured to me (light dawns on marblehead) - perhaps this needs to be done via the CLI?
TIA.
Hi,
Check out the below link
http://portforward.com/routergui/Linksys/SRW2008/Jumbo_Frame.htm
Hope to Help !!
Ganesh.H
Remember to rate the helpful post
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide