VRRP/HSRP CISCO 3560

[O&M MPLS CNT]

Hi.

Today I tried to config a HSRP group on a Vlan A and VRRP on a Vlan B, in that order. But, When enter vrrp 30 ip x.x.x.x, it showed me an error telling me that I'm wrong about FHRP group number. This was on a Cisco3560.

To solve this and be able to configure VRRP, I had to delete HSRP config at all from my switch.

Is it normal on that platform? Is there any restriction related?

Thanks

[Francesco Molino · Accepted solution]

Hi

The switch support both protocols but not at the same time :

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3560/software/release/12-2_58_se/configuration/guide/3560scg/swhsrp.html#47648

See VRRP Limitation chapter.

PS: Please don't forget to rate and mark as correct answer if this solved your issue 

[O&M MPLS CNT]

Hi Supportlan.

Thank you so much. I read restrictions.

You are right.