Switches - Small Business

Dear  I need to know if this switch " WS-C2960-24PC-S " support the DHCP snooping and the ARP protection . 

Hi, everyone  I am about to buy this switch (Cisco SG200-50) but before that, i would like to know if it has the feature of managing the bandwidth of each port, Best regards, 

Greetings,  i Have an SG300 L3 mode switch connected to multiple other access SF300 switches in L2 mode and around 400+ devices on my network(most of them light mobile users). I noticed that my TCAM utilization is close to 450 and i am suffering from...

The company I work for requires an annual reboot of the Cisco 4006 and 4506 routers. As the technical writer I must put the procedures in a manual. The routers in normal operations with no problems. Can you direct me to CIsco documentation that woul...

Hi All, I am currently setting up Nagios to monitor our switches via snmp. I have got a  few checks working by hunting down the required OID for CPU usage and fan speed but I am struggling to find the MIB or OID for memory usage and network in/out.  ...

MGBLH1 interface card are compitible for wich models cisco switch please mention,

GLC-SX-MMD interface card for which models are compitible in cisco please mention

Hi, i have a SG300-10MPP 10-Port Gigabit PoE Managed Switch and would like to boot my HP Workstation Notebook with Wake On Lan. Does the Switch support Wake On Lan? Are there some configuration steps to do for this service? bye Oskar

Hi, does latest firmware 1.3.1 supports CLI? I am trying to see mac address table. So far I can't manage to find it via Web view, or access to lcli / CLI? Do you have a suggestion? Thanks in advance

I recently purchased a Cisco SG110D-08GHP switch for my company.  This is meant to be our main switch for routing our internet throughout the building.  Unfortunately, when I go through the switch our upload speeds are getting reduced to almost nothi...

I've a stack consisting of two SG550XG-8F8T switches. Last night the stack restarted, apparently because of a segmentation fault error: 07-Nov-2016 23:00:19 :%STCK SYSL-A-UNITMSG: UNIT ID 2,Msg:%SYSLOG-F-OSFATAL: caught segmentation fault exception a...

12 Cisco SG500-52P switches on SW 1.4.5.02 and boot 1.4.0.02. These are all over the offices, some in stacks, some not. One stack does this all the time. Switch is now unusable from web or console.  07-Nov-2016 12:15:11 %HAL_config_poe-A-POEFailDetec...