cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4665
Views
0
Helpful
5
Replies

10Gb Ethernet on 3750X

waqas gondal
Level 1
Level 1

Hi,

I have a question about the SFP/SFP+ modules on the 3750X switch stacks.

Is it possible to use all 4 ports as 10Gb at the same time or will it be reduced to 1 GB for each port?

Thanks,

Waqas

2 Accepted Solutions

Accepted Solutions

Collin Clark
VIP Alumni
VIP Alumni

You can use only two 10Gb at a time in the module. If you prefer 1Gb, then you can use all four. You can use one 10Gb and two 1Gb as well.

View solution in original post

The interface for all four 1Gb and the two 10Gb are in the config even if they are not used. Refer to Table 4 in this link.

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps6406/data_sheet_c78-584733.html

You can't use RJ-45 10Gb. Purchase the Twinax, it's substantially cheaper.

http://www.cisco.com/en/US/prod/collateral/modules/ps5455/data_sheet_c78-455693.html

Also here is the compatibilty guide for 3750-X's and 10Gb optics

http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_6974.pdf

View solution in original post

5 Replies 5

Collin Clark
VIP Alumni
VIP Alumni

You can use only two 10Gb at a time in the module. If you prefer 1Gb, then you can use all four. You can use one 10Gb and two 1Gb as well.

Thanks,

The reason I ask is because I am using the 2 of the 1Gb SFP but the TenGig ports show as down down. I was wondering if it was possible to use both at the same time.

Also, is it possible to use the 10Gb ports with an RJ45 connector?

The interface for all four 1Gb and the two 10Gb are in the config even if they are not used. Refer to Table 4 in this link.

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps6406/data_sheet_c78-584733.html

You can't use RJ-45 10Gb. Purchase the Twinax, it's substantially cheaper.

http://www.cisco.com/en/US/prod/collateral/modules/ps5455/data_sheet_c78-455693.html

Also here is the compatibilty guide for 3750-X's and 10Gb optics

http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_6974.pdf

Thank you very much Collin!

**You can use 10G-T if you have that specific module

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: