1941 configuration with range of WAN ip addresses

[robbie.teo]

Hi,

i have a 1941 router tt needs to be setup with the range of WAN ip addresses

ip nat inside outside don't allow me to use it

For example,

WAN --------- (129.1.1.1/30)  Router ( 129.2.1.1/28) -------------------- (129.2.1.2) Firewall

How can i configure on the router to ensure from outside i'm able to access to firewall (129.2.1.2) ?

PLs Advice. Thanks

[Eugene Khabarov]

For what purpose you need access your firewall? Is it management requirements? Do I understand you right that you can't use NAT on your wan interfaces?

---

HTH. Please rate this post if it was helpful. If this solves your problem, please mark this post as "Correct Answer."

[robbie.teo]

For Vpn access.

If i use NAT, i can't be able to access the firewall WAN ip address.

Any advice on this? thanks.

[Eugene Khabarov]

Confiuration will be helpful here...

[johnlloyd_13]

Hi Robbie,

You don't need NAT. Just assign your FW with the public IP address 129.2.1.2/28 and it shoud be routed or accessible from the Internet.

Sent from Cisco Technical Support iPhone App