2 IP address

cavementech · ‎07-06-2023

On several switchports, I have two IPs for the same MAC address. They have 0.0.0.0 and then the real IP that is associated with the device. I'm not sure why it is doing that or how to fix it.

The WAP has been plugged in and online for months. Everything is working and flowing traffic correctly, just seems like it should not be showing 0.0.0.0 on the port details.

aleabrahao · ‎07-06-2023

Are you facing some issue?

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

cavementech · ‎07-06-2023

No, there are no issues. Everything is working properly, just trying to understand why it is populating 0.0.0.0 as well.

aleabrahao · ‎07-06-2023

I think you need to wait some time. Some information take some time to update on the dashboard.

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

cavementech · ‎07-06-2023

This specific WAP has been in place for months. I'll continue to monitor it though. I have many switchports doing the same thing across my organization. Some have been in place for years.

aleabrahao · ‎07-06-2023

Is the device an Access point? Is it receiving IP via DHCP?

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

cavementech · ‎07-06-2023

This is a Meraki MR84 and is assigned a DHCP IP.

Raphael_L · ‎07-06-2023

When booting , some Meraki devices like to use a combo of 0.0.0.0 or 6.x.x.x . That might be the case. Has the AP rebooted recently ?