2 Vlans on one Switch port

[KipCool]

Hello,
I have an access point connected to a port on the Switch.
The access point can broadcast several SSIDs associated with different VLANs (VLAN1 - untagged + VLAN50 - Tagged).

How to configure the switch port to have VLAN1 - untagged and VLAN50 tagged?

Thanks in advance and best regards.

[Georg Pauwen]

Hello,

what are you after exactly ? The only way to have a switchport carry multiple Vlans is to configure the port as trunk. Vlan 1 is untagged by default, all other Vlans are tagged.

[balaji.bandi]

You can configure just as Trunk port  on switch allowed only required VLANs.

by default vlan 1 untagged in cisco world.

[KipCool]

Are the following commands corrects ?

Interface gi0/3
switchport mode trunk
switchport trunk allowed vlan 1,50

And how to configure the vlan50 on all the ports of the Switch in a single command?

[balaji.bandi]

This configuration required only where the AP / WLC connected -hope that works ?

VLAN 50 need to be required all the switch where required in the path

[KipCool]

how to add the vlan50 (Tagged), and keep the Vlan1 (Untagged) on all the ports of the Switch in a single command ?